WH Software Knowledge Base

InstaCode & the Silca Triax

When communicating with a Silca Triax or a Silca Tri-Code/Viper machine, InstaCode only has the ability to call up the Silca on-board card via the Silca Serial Number (SSN) if it exists within the current Silca firmware.  If this is the case, then InstaCode only provides/populates the bitting.

The entire cutting process from start to finish is controlled by the on-board Silca card.




Article Details

Last Updated
29th of May, 2014

Would you like to...

Print this page Print this page

Email this page Email this page

Post a comment Post a comment

Subscribe me

Add to favorites Add to favorites

Remove Highlighting Remove Highlighting

Edit this Article

Quick Edit

Export to PDF

User Opinions ( )

How would you rate this answer?



Thank you for rating this answer.

Related Articles

No related articles were found.

Attachments

Continue