WH Software Knowledge Base

Continue

Advanced Search

  Query:
  Categories:
  Rated:

Search Results for "number"

There were 11 articles found for your query: 

  1. Vin to Key CodeVin to Key Code [Article]
    The prospect of calculating mechanical key codes from a vehicle’s VIN number is simply not possible. This is because of a number of reasons: There is no collation betwee
  2. My PC has died how do I remove the allotted activation.My PC has died how do I remove the allotted activation. [Article]
    When an organisation decides to upgrade their computers they systematically de-activate the software off the old computers. This procedure reinstates their activation count limit which will en
  3. InstaCode & the Silca TriaxInstaCode & the Silca Triax [Article]
    When communicating with a Silca Triax or a Silca Tri-Code/Viper machine, InstaCode only has the ability to call up the Silca on-board card via the Silca Serial Number (SSN) if it exists within the c
  4. Communication problems with Silca UnoCodeCommunication problems with Silca UnoCode [Article]
    Setting up your Silca UnoCode is very straight forward with only two fields requiring correct selection. Com port 1 is normal for serial to serial communication, otherwise a USB to ser
  5. Key Codes from VIN Numbers in InstaCodeKey Codes from VIN Numbers in InstaCode [Article]
    InstaCode does not contain information to allow you to cut a key from the VIN number. It is purely from the Key Code itself on the particular vehicle. Key codes can be obtained from a
  6. I am getting an error when trying to communication with my Silca Key Machine - Silca Error 5002?I am getting an error when trying to communication with my Silca Key Machine - S... [Article]
    The most common error you will see when trying to communicate with a Silca machine is: Silca Error 5002. A simple process of elimination will solve the problem. Open the machin
  7. How do I find and use PIN Code convertersHow do I find and use PIN Code converters [Article]
    InstaCode has a number of tools for performing calculations pertaining to the immobiliser PINs of vehicles. In InstaCode these calculation tools are referred to as "Plugins". To access
  8. Silca Leonardo Key Cutting Machine Requirements And OperationSilca Leonardo Key Cutting Machine Requirements And Operation [Article]
    The Silca Leonardo machine was produced to be a stand alone key duplicating machine. WH Software identified a greater use for the Leonardo as a means to improve productivity when manufacturing
  9. Why can't some series such as Audi/Volkswagon be cut on my ITL machine?Why can't some series such as Audi/Volkswagon be cut on my ITL machine? [Article]
    ...ITL, some series require multiple cuts in each position to produce an accurate key. If the required number of cuts is more than 12, InstaCode cannot download the data to the ITL machine. This
  10. What are the token positions for my Marker 2000?What are the token positions for my Marker 2000? [Article]
    To set up the Token positions on the Marker 2000 Token 0 holds the key number Token 4 holds the issue number Token 5 holds the system number Hence marking mod
  11. How do I select the correct Silca UnoCode Classic machine?How do I select the correct Silca UnoCode Classic machine? [Article]
    Overview When adding an Original/Classic UnoCode to the machine list you must choose if your machine is a version 1 or a version 2 machine. The majority of these older machines are