WH Software Knowledge Base

I am getting an error message of Coding Not Complete in ProMaster Masterkeying 7?

There are three reasons why coding may not be not complete, these follow for you:

  1. Phantom check is not complete.
  2. All keys have to have codes within Coding Tree and Assign Codes.
  3. All doors must have keying or if not, their properties changed to Non Keyed as shown below. To check this, go into Doors and change the Keyed status on the left, to show “Doors with no keys assigned” and hit Find.

Check these things and make any changes, then do a Phantom Check again which will mark the system as Coding Complete.




Article Details

Last Updated
26th of October, 2011

Would you like to...

Print this page Print this page

Email this page Email this page

Post a comment Post a comment

Subscribe me

Add to favorites Add to favorites

Remove Highlighting Remove Highlighting

Edit this Article

Quick Edit

Export to PDF

User Opinions ( )

How would you rate this answer?



Thank you for rating this answer.

Related Articles

No related articles were found.

Attachments

No attachments were found.

Continue